Bench Protocols for MG1 China
Version 6.61 of Flex out now
New Flex release out now: download the version 6.61.0.0 and enjoy Bench protocols for MG1 China engine units installed on Asian vehicles such as ChangAn UNI-K and Cirelli 5, equipped with 1,5L and 2,0L turbo petrol engines.
The two engine units that have been added to the vehicle list are:
- MG1UA008
- MG1US008
Try the latest update of Flex, get a taste of Bench protocols for MG1 China and obtain access to Flash and EEPROM memories: elaborate files to enhance engine parameters.
Some of the supported vehicles:
- ChangAn UNI-K 2.0L Turbo 235PS
- Cirelli 3 (G01F) 1.5L Turbo 156PS
- Great Wall Haval (H6) 2.0L Turbo 230PS
- Proton X50 1.5L Turbo 150PS
This new protocol is available for the following software packages:
Bench
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5M – SW Flex Full Slave
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
Newly added protocols:
(BENCH)
- All Bosch MG1US008 TC277 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
- All Bosch MG1UA008 SPC574 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
Reading Time: ~ 12 minutes Writing Time: ~ 30 seconds
Bug Fixes:
- Added new CRC type for FCA Bosch MD1CS049
- Added new CRC type for Hino Denso SH72543
- Added new CRC type for FCA Marelli MM10JA
- Added new CRC type for Kia/Hyundai Kefico CPEGD2.20.3
- Added new CRC type for Suzuki Marelli 8DS
- Added new CRC type for Kia/Hyundai Continental Sim2k-341
Software Improvements:
- Added Support for Volvo Bosch ME7.0.1 Boot